The MCT-100 is a fully supervised PowerCode™, two-input wireless transmitter. 
Each input has its own individual 24-bit PowerCode™ ID which identifies it to the target receiver. 

APPLICATIONS
Domestic, commercial and industrial

This device is particularly useful to collect information from existing wired alarm control panels or circuits.

FEATURES
* Ultra-low current consumption
* Two input channels
* Individual ID on each channel
* Signal anti-collision
* Fully supervised




SPECIFICATIONS
Frequency (MHz): 315, 404, 418, 433.92 or other frequencies according to local requirements
Transmitter's ID Code: 24-bit digital word, over 16 million combinations, pulse width modulation
Overall Message Length: 36 bits
Alarm Inputs: 2, each with a separate 24-bit transmitter ID
Input Circuit Type: NC/EOL, selected with on-board DIP switch
EOL Resistor Required: 47 k ohm
Message Repetition: Once every 3 minutes, or one-shot - as selected with on-board DIP switch
Supervision Method: Automatic reporting at 1-hour intervals for each input
Response to Tamper Event: Report every 3 minutes until the switch is restored 
Power Source: 3.6 V lithium battery
Nominal Battery Capacity: 1.2 Ah
Current Consumption: 5 uA standby, 6 nA in operation (incl LED)
Battery Life (with LED on):
@10 transmissions per day: More than 10 years
@ 50 transmissions per day: about 6 years
Battery Supervision: Battery condition data transmitted as part of any status report
Compliance with standards: Meets FCC Part 15, ETS 300-220 and MPT1349
Operating Temperature: 0°C to 49°C (32°F to 120°F)
Dimensions: 110 x 63 x 25 mm (4-5/16 x 2-1/2 x 1 in)
Weight: 66.5 g (2.34 oz